 |
Standard
Way Wipers 
(available in 1 meter lengths unless otherwise noted)
KabelSchlepp Way Wipers are
available in standard 1 meter lengths which can then be cut and
formed by the customer to fit a specific application.
 |
When
ordering, please specify type and size (e.g.
BA25; BAS25).
Optional
copper alloy hot-chip shields available for Type
BAS in 1/2 meter lengths.
|
|
Table
Of Heights
|
Order
No. |
Unmounted
Height |
Mounted
Height |
 |
BA18 |
0.708"
(18mm) |
0669"
(17mm) |
| BA25 |
0.944"
(24mm) |
0905"
(23mm) |
| BAS18 |
0.708"
(18mm) |
0.669"
(17mm) |
| BAS25 |
0.944"
(24mm) |
0.905"
(23mm) |
BAS40
|
1.575"
(40mm) |
1.535"
(39mm) |
SPECIFICATIONS
- Length:
Standard length of 39.4" (1000mm)
- Height:
0.669" (17mm), 0.905" (23mm), and 1.535 (39mm)
mounted
- Frame: Solid,
non-corrosive aluminum alloy. Type BAS has protection of
blade from hot chips
- Blade:
Polyurethane. Long wearing and resistant to oil, cooling
agents, most chemicals. Will withstand temperatures up to
200°F
- Tension:
0.0394" (1mm)
 Optional
Hot-Chip Shields
For additional protection
from hot chips , KabelSchlepp offers a preformed copper alloy strip
for use with Type BAS that can be attached with mounting screws. The
hot chip shield provides complete protection for the wiper blade
from hot chips and will not scratch the slide-way surface.
| EASY
FOUR STEP INSTALLATION |
|
1.)
MEASURING:
KabelSchlepp makes it easy for you to install
way wipers on your machines with minimal
downtime. Simply order stock lengths and measure
slide-way to be protected. |
2.)
CUTTING:
Lightweight aluminum alloy frame with wiper
blade in place is easily cut to required lengths
and angles. Even a hand saw may be used. |
|
|
3.)
PINNING:
Drill two holes in frame through each angle.
Hammer in roll pins for secure joint.
Polyurethane blade sections should be glued
together at corners to ensure a tight seal.
KabelSchlepp simplifies wiper assembly by
eliminating welding of frame corners. (NOTE:
Wiper sections may be mounted directly on
machine without pinning.) |
4.)
MOUNTING:
Drill holes through
the metal frame and drill and tap the moving
part the of machine. Attach the way wiper to the
machine. |
<<Back
To Way-Wipers Main Page>>
|
